Construction ID:
Floor Finishes: All Floor Finishes (Caution with Tiles and Stone)
Construction Height:
20¹
mm
Mass:
31²
kg / m²
Thermal Resistance (R-value):
0.75³
m² K / W
Uniform Distributed Load (UDL):
2.0
kN / m²
Point Load (≥ 20 cm²):
2.0
kN
Impact Sound Reduction:
–
dB
¹ System sites between joists minimising construction height.
² Excludes floor finish.
³ Part L compliant for floors above heated rooms.
Area of Application:
- Floors with rooms of equal temperature above and below, and a minimum R-value of 0.75 m² K / W.
- This construction is suitable for use on intermediate floors, no further insulation is needed to meet the Part L requirements.
- For ground floor installations refer to Construction ID: STR-BJ3G.
Additional Information:
- When installed, the Fermacell elements may follow any undulation that occurs from the joists. This may need to be taken out with the use of a thin levelling compound.
- Aluminium diffuser plates should be flush with the top of the joists.
Floor Finishes:
All Floor Finishes (Caution with Tiles and Stone)
Construction Height:
20¹ mm
Mass:
31² kg / m²
Thermal Resistance (R-value):
0.75³ m² K / W
Uniform Distributed Load (UDL):
2.0 kN / m²
Point Load (≥ 20 cm²):
– kN
Impact Sound Reduction:
– dB
¹ System sites between joists minimising construction height.
² Excludes floor finish.
³ Part L compliant for floors above heated rooms.
Area of Application:
- Floors with rooms of equal temperature above and below, and a minimum R-value of 0.75 m² K / W.
- This construction is suitable for use on intermediate floors, no further insulation is needed to meet the Part L requirements.
- For ground floor installations refer to Construction ID: STR-BJ3G.
Additional Information:
- When installed, the Fermacell elements may follow any undulation that occurs from the joists. This may need to be taken out with the use of a thin levelling compound.
- Aluminium diffuser plates should be flush with the top of the joists.
